All Things Pink – We had lots of fun today! Alex Schady put on a fab pink themed workshop. If I’m totally honest I struggled to get my sculpture to ‘work’ exactly as I wanted it to, but it was still a great session! I got a little sidetracked by some of the materials I was using. I became quite absorbed by the layers of plastic that I could create. However, the project brief required the sculpture to hold a smartphone. Unfortunately my sculpture was a little flimsy and my phone very heavy, so it was a recipe for disaster. Luckily my creation just about managed to make it to the end of the day. Below is a picture of Alex Schady in the photographic studio wearing his sculpture. I really liked Alex’s creation, which was a much better and more solid design for holding a smartphone. Shots of My Creation Below are some shots of my strange pink layered sculpture. Sadly it really struggled to hold my heavy iPhone. However, I did manage to shoot some video. Textures I was really intrigued by the textures created by the plastic layers of my creation. So when […]
Small Steps – Big Changes. I had to write yesterday off almost completely as I had so many non MA activities to complete. These duties ranged from setting up a new phone for a family member, to composing and posting an important letter. However, today was much more productive. I managed to test my concept and augment a number of my mobile elements. Early indicators suggest that ‘all things going well’ – I should be able to realise my vision. My greatest fear was that the mobile wouldn’t augment very well. I also worried that the elements were too close together, and as such would interfere with one another when augmenting. It appears that as long as the user/viewer is careful then each item should augment separately. Up to this point it has been a bit of a risk. Today the concept however was tested and seems to work. Athena the robot continues to 3d print but this activity is also not without risk. Jamie (my collaboration partner’s) 3d printer isn’t always consistent and parts often become loose from the 3d printer bed. This ultimately leads to print failures which is slowing down the project. On a more positive […]
